after installing 10.8 boot0 error fix with wd drive
Posted: Sun Nov 25, 2012 12:12 am
1. install the usb tool using unibeast and the 10.8 store image or usb key you bought (another tut)
2. install as normal (use any usb ports connected to cabling on the board not the board's rear usb connections for key-mouse)
3. restart and see the boot0 error
4. startup again from the usb installer
5. goto disk utility and look for the new drive with mountain lion 10.8 on it (MLionPC for ex)
6. right click and unmount it
7. close dick utility
8. open terminal
9. list your disks and partitions:diskutil list
"Mac OS X Base System" ML installer USB
"MLionPC" where OS X ML was installed but cannot boot [boot0 error]
MlionPC disk7s2
dd if=/Volumes/"Mac OS X Base System"/usr/standalone/i386/boot1h of=/dev/disk7s2
2 of two files moved
exit
restart
2. install as normal (use any usb ports connected to cabling on the board not the board's rear usb connections for key-mouse)
3. restart and see the boot0 error
4. startup again from the usb installer
5. goto disk utility and look for the new drive with mountain lion 10.8 on it (MLionPC for ex)
6. right click and unmount it
7. close dick utility
8. open terminal
9. list your disks and partitions:diskutil list
"Mac OS X Base System" ML installer USB
"MLionPC" where OS X ML was installed but cannot boot [boot0 error]
MlionPC disk7s2
dd if=/Volumes/"Mac OS X Base System"/usr/standalone/i386/boot1h of=/dev/disk7s2
2 of two files moved
exit
restart